Table of Contents
Advertisement
Instruction Manual
2.3
Electrical Installation
6888Xi Advanced Electronics
WARNING
Disconnect and lock out power before connecting the power supply.
WARNING
Install all protective covers and safety ground leads after installation. Failure to install covers and
ground leads could result in serious injury or death.
WARNING
To meet the Safety Requirements of IEC 1010 (EC requirement), and ensure safe operation of this
equipment, connection to the main electrical power supply must be made through a circuit breaker
(min 10A) which will disconnect all current-carrying conductors during a fault situation. This circuit
breaker should also include a mechanically operated isolating switch. If not, then another external
means of disconnecting the supply from the equipment should be located close by. Circuit breakers or
switches must comply with a recognized standard such as IEC 947.
NOTE
NOTE
NOTE
Installation
Section 2: Installation
15
Advertisement
Table of Contents
