Cleaning The Hood; Light Bulb Replacement - Sirius Range Hoods SU1 Installation Instructions Manual

Cleaning the Filter
The aluminium mesh filters should
be washed by hand or in the
dishwasher as required. Damaged
and worn filters must be replaced
immediately. (Do not operate blower
when filters have been removed).
Allow filters to dry before replacing
them, otherwise water will be drawn
into the blower.
If a carbon filter has been fitted, it
must be replaced every 6 months as
a minimum, depending on usage
and type of cooking
performed.
It is suggested that a spare set of
carbon filters is kept on hand.
These can be ordered from the
supplier of your range hood.

Cleaning the Hood

The outside and interior of your hood
should be wiped regularly with a
clean, damp cloth
household dish detergent
degreaser.
Use a good quality non-abrasive
foaming type stainless steel cleaner
for exterior surfaces.
Follow the manufacturers directions
– generally the foam is sprayed onto
a clean dry cloth and then applied to
the stainless steel. Allow the foam
to react on the surface for a few
minutes and then wipe with a clean
dry cloth.
On the surfaces that are exposed
directly to heat from the cook-top, it
is advisable to clean these regularly
to avoid the deposits from becoming
baked on.
Do not use abrasive cleaning agents
as these will destroy the brushed
finish.

Light Bulb Replacement

(If in doubt, call 866-528-4987)
Turn blower and lights off.
sure the lights are cool.
Do not remove the entire fixture
(socket) as this is very difficult to
reinstall.
that is
Visually inspect the light fixture and
establish whether the unit has a
smooth or "toothed" metal ring.
If smooth, remove the glass block-
ing ring by prying out with a sharp,
soft instrument such as a toothpick
(refer to figure 17). Steel instruments
will scratch the surface. Be careful
that the lens does not fall out.
and mild
or
Figure 17
If " toot he d",
place the tip of
your finger
tween the lens
and
Making your way
around the ring, gently pull outwards
until a point is found where the ring
pulls off (refer to figure 18).
Replace the appropriate bulb. Check
parts
sheets on our website. Wipe both
sides of the glass whilst it is out.
Fixture
Lens
Glass blocking ring
be-
Figure 18
the ring.
brochure or specification
Make
"Toothed
Ring"
8