Security - Extech Instruments 7630 Operation Manual

If you attempt to start a test from the front panel Test button and the PLC remote function is
turned "ON", a pop-up message will be displayed. The pop-up message will appear as
follows:

4.1.4 Security

From the System Setup screen, press the "Security" soft key. One of two possible Security
screens will be displayed. The Security screens appear as follows:
Initially, the instrument will not have a password enabled and the Security setting screen will
appear (screen on the left, refer to the above illustrations). You may create a password from
this screen so that all security functions will require a password to access. From the Security
settings screen, three different parameters may be accessed, Create Password, Security and
File Recall.
If a password has already been created then the Security password screen (screen on the right)
will appear and typing in the correct password will be required to access the Security setting
screen. From the password protected Security settings screen, three different parameters may
be accessed, Change Password, Security and File Recall. The Security setting screen that
will appear after a password has been created and entered correctly, will appear as follows:
P L C r e m o t e
C o n t r o l
F r o n t p a n e l T E S T
.
d i s a b l e d
or
i s O N
b u t t o n i s
43