Laskomex CD-2502 Series Installation, Service And Programming Manual page 45

9.7 User's menu
register new electronic keys.
To make changes an occupant must activate user's menu. Some person in the
apartment must help.
User's menu activation:
a) Make connection with the apartment (only from the subordinate entrance
panel).
b) Press button with a sign of a key and while pressing it ask a person in the
apartment to press the catch button five times. Activation of a function
is signaled with three short signals in uniphone receiver and external panel
and also with message [OPC] displayed temporarily on the external panel's
display.
c) Finish the conversation.
d) Enter the apartment number and press button KEY .
NOTE! If parameter CHA is set up on value "1" then after pressing
button KEY code of coded lock should be entered. On the display
user's menu will be shown, where parameter's edition is available. (see dwg.
20).
1 The first sign on the display defines calling tone (0...7). Calling signal can
be changed by pressing the key marked with number [1].
2 The second sign on the display defines volume of calling signal (G - loud,
N - increasing, C - soft, U - moderate). Selection of increasing signal is
sensible at the number of rings higher than 1. Volume is controlled with
key [2].
3 The third sign on the display defines the number of rings (1-8) - decides
how long the uniphone rings. Number of signals is controlled with key [3].
Change of coded lock code
To change the code of coded lock, user's menu should be activated and key [0]
should be selected. For a moment messages [NEU] and [CODE] and then four
horizontal bars will appear and then new code of coded lock should be entered.
New code should be entered twice. Option of changing the code by the user
can be blocked by an installer!
Calling volume
Calling tone Number of bells
1
2
Figure 20: User's menu
44
9 ENTRY PHONE USE
3