Laskomex CD-2502 Series Installation, Service And Programming Manual page 31

CAin Supported video in-
puts
CAtP Time interval [s] of
switching video sig-
nal
nbL Block number
Pnu Range shift
LPi Amount of rooms on
the floor
LLo Range of serviced
numbers – low value
LHi Range of serviced
numbers – high
value
LdP Directing of not ser-
viced numbers
NbP Block number for di-
recting of not ser-
viced numbers
U Additional number
not included in the
serviced range
Video signal service
0...1234 0 U Inputs of CVP-x switch which are serviced by CD system. Value
'0' of parameter means using a CVP-1 switch, while a value
greater than zero means CVP-2 switch - the individual digits in the
number means which inputs in the switch are used (eg. CAin=124
- picture from inputs 1 - H el. cassette, 2 - U el. cassette and 4
- additional camera eg. from parking lot)
1...10 3 U Switching interval between images from the cameras while preview
is active - eg. parameter value CAtP = 3 will result in switching
pictures from video inputs every 3 seconds.
Kind of numbering
0...9998 0 U Value above 0 is set in electronic cassette servicing subordinate
entrance switches on mode with building numbering. This mode
will operate properly if in electronic cassette, which services the
main entrance, mode with building numbering is switched. Details
in item "Numbering", see page 9.
0...9998 0 U Parameter used in numbering mode with range shift. Details in
item "Numbering", see page 9.
0...100 0 U Parameter used in hotel numbering mode in which room number
is preceded by a digit which defines the floor on which the room
is located. Details in item "Numbering", see page 9 .
1...240 1 U Parameter is used to set number range which is serviced by an en-
try phone. After selecting a number outside this range a message
will appear on the display OFF . Limiting the range is recom-
mended especially in case of an entry phone in a multi-entrance
version. Be careful that LLo
number will result in displaying a message OFF .
1...240 240 U Parameter is used to set number range which is serviced by an
entry phone.
0...9998 0 U,H All numbers which are not serviced by entry phone CD-2502, will
be directed to uniphone number given as LdP value (see item 4
page 9).
0...9998 0 H All numbers which are not serviced by entry phone CD-2502, will
be directed to uniphone number given as LdP value, connected to
electronic cassette which parameter nbL is the same as parameter
NbP (see item 4 page 9).
0...9998 0 U
Number introduced as a value of this parameter will be assigned
as a logical number of uniphone of physical number .
NOTE: If additional number will be the same as number that
is already used, then the physical number that is assigned to
this additional number will have a priority. This also applies
to all individual settings.
30
8 PROGRAMMING OF ENTRY PHONE
- number from the range 241...254
LHi . otherwise selecting of any