Laskomex CD-2502 Series Installation, Service And Programming Manual page 36

P-4-2 AdL Addition of key
with attributing
to apartment
P-4-3 AdP Programming
of key on the
selected item in
memory
2
4
U
Procedure enables adding of key and attributing it to selected apart-
ment number, which facilitates keys management. The use of the key is
signalled in uniphone receiver as in the case of combination lock. Pro-
gramming is realized as follows:
After activation P-4-2 on the display a flashing message will appear
L- - - .
Give apartment number and confirm it with key KEY . Digit on
the display will flash slowly.
Apply key to the reader. On the display a message Add will
appear for a moment and a number of memory item in which key
number is saved.
When on the display a flashing apartment number reappears next
key for this apartment can be registered.
Key KEY . should be used for registration of keys for next apart-
ments. When message L- - - appears on the display the operation
should be repeated.
4
U,H
Key can be programmed in the selected item in key memory. Function
is used for registering next special keys, because memory cells in which
the keys are saved are protected against recording in other way. To
reset special key or service key procedure P-4-6 should be used. Key
organization in memory is as follows:
Operation mode
Regular keys
Special keys
Administrator's keys
Registration of keys is as follows:
Start procedure P-4-3. On the display message AdP will appear
and after a while P—
Give item number and confirm by KEY . Message will stop flash-
ing.
Apply the key to reader. On the display message Add . will
appear.
Repeat the operations for the following keys or finish it with KEY
key
35
8 PROGRAMMING OF ENTRY PHONE
APARTMENT POSITION
NUMBER IN MEMORY
1 0
APARTMENT
NUMBER
3 1 5
EC-2502/U EC-2502/H
0-999 0-1999
1000-1019 2000-2039
1020-1023 2040-2047
END OF OPERATION