Electronic Keys - Laskomex CD-2502 Series Installation, Service And Programming Manual

Entry phone CD-2502 can be equipped with iButton and/or RFID electronic key reader. There are three kinds of
keys in entry phone. Service keys enable change of entry phone configuration, special keys are used by postmen,
administration etc. and keys for the occupants.
Keys should be registered at both the main and subordinate entrance. At the main entrance keys attributed to
apartment cannot be registered.
Entry phone users can register their own electronic keys (see page. 43). This possibility can be switched off globally
in procedure P-2 by setting parameter [iba] to value "0" or individually in procedure P-5.
Electronic keys can be used after their earlier registration in entry phone memory. Registration includes the activation
of procedure (P-4-1 or P-4-2) and applying the key to the reader.
P-4-0 C0 Resetting
electronic key
memory
P-4-1 Add Addition
key without
attributing to
apartment
P-4 Electronic keys
4
U,H
Procedure is used for resetting all keys stored in entry phone system
memory. Administrator code should be given to protect against accidental
resetting. After having given the code or having used the service key during
resetting time on display message CLR and tst will appear. Procedure
results in resetting of all user's code and service key codes which lasts
approx. 5 sec.
4
of U,H
After applying the key to the reader its serial number will be read and
stored in entry phone memory. On the display the following messages
will be shown Add , NEU and xx ,where xx is a number which defines
number of memory cell in which key number was saved. If the key has
already been saved in entry phone memory a message OLD will appear
on the display. An installing specialists cannot change the item in which
key number is saved. The key is registered in the next free memory item.
An installing specialist can make a list in which key position in memory as
well as the name of a person to which the key will be given. It is important
in the case when the key has to be deleted from the memory, however this
method is not comfortable.
8 PROGRAMMING OF ENTRY PHONE
Installing
specialist`s
code
1 2 3 4
0
1
34
CELL
NUMBER
IN MEMORY
C