Roland LEC-300 Supplemental Manual page 11

3.
Press .
4.
Use
LENGTH UNIT
mm mm
5.
Press .
6.
Use
TEMP. UNIT
C C
7.
Press .
2. Clean the print heads using the SOL INK cleaning cartridge
(LEC- 330/540,LEJ-640)
* In the case of LEF-12, go on to "2 .Clean the print heads using the SOL INK cleaning cartridge (LEF-12)" (p . 11)
1.
Check the selected ink mode .
SELECT INK TYPE
ECO UV CMYKGlW
Ink mode
Gloss mode
White mode
Gloss/White mode
EUVS ink mode
MEMO
When an incorrect ink mode is selected, switch off the sub power once .
Again carry out the procedure "Selecting the Ink Mode" (p . 4) .
2.
Press
Ink type
EUV ink
EUV3 ink
MEMO
When the EUVS ink mode is selected, the ink type is fixed to "ECO-UVS . " (It cannot be changed .)
to select the unit of measurement you want (for length) .
to select the unit of measurement you want (for temperature) .
Ink mode display
Ink mode display
ECO-UV CMYKGlGl
ECO-UV3 CMYKGG
ECO-UV CMYKWW
ECO-UV3 CMYKWW
ECO-UV CMYKGlW
ECO-UV3 CMYKGlW
ECO-UVS CMYKWW
to select the ink type .
Display screen
SELECT INK TYPE
ECO UV CMYKGlW
SELECT INK TYPE
ECO UV3 CMYKGlW
Installing the Ink Cartridges
1. Changes to the Setup Guide
9