Connecting The Analog Outputs; Connecting The Relay Outputs; Connecting A Pc - Accusonic 8510+ series Reference Manual

Connecting the Analog Outputs

Connect to the 4-20mA terminals as indicated in the following Figure 4-6.

Connecting the Relay Outputs

On most systems the terminal strip for the relays is located on the extreme right hand end of the connector
panel shown in Figure 4-6. The labeling on the flowmeter and the Customer Specific drawings at the back
of this manual will indicate the terminals to be used.

Connecting a PC

A PC may be connected to the 9 pin "RS-232" socket or the RJ45 "Ethernet" socket, for use with special
Accusonic PC based programs. The "RS-232" connection requires a "Null-Modem" connection and the
"Ethernet" connection requires a "Cross-Over" LAN cable or a standard LAN cable if connection via a
switch or router. Either the cable or adapter can be purchased at a PC supply or electronics store.
If the user supplied PC does not have serial ports available, a USB to Serial adaptor can be purchased at a
PC supply or electronics store. Not all USB to Serial adaptors can be used for this purpose. Contact
Accusonic for recommendations when purchasing a USB to Serial adaptor.
Unpacking and Installation 4-9