Robot Stop; Prolonged Inactivity And Restarting - AMBROGIO 6060BA0 User Manual

the robot stops automatically if the following conditions are detected:
•
lawn mowed: the sensor has detected that the lawn has been mowed and therefore, does not require further mowing.
Recharge the batteries and start the robot again after one or two days based on the growth of the grass.
•
no grass present: the grass sensors have not detected the presence of grass for an extended period.
•
discharged batteries: the batteries have used up their operating capacity.
•
batteries in protection: when the batteries have reached a capacity which is lower than the level of the discharged batteries,
the robot completely turns off without displaying any indication. In this case, connect the robot to the recharger. The robot will
not turn on immediately, as normally occurs, but only after a few minutes.
IN PAUSE
C. PLAY/PAUSE:
(YELLOW LED STEADY ON)
in pause / in pause due to low battery.
(YELLOW LED SLOW FLASHING)
Robot in standby. Press the PLAY/PAUSE
key to display the status of the LEDs.
(YELLOW LED 1 FLASH)
1
the lawn has been mowed.
(YELLOW LED 2 FLASHES)
2
no lawn present.
After a long period of inactivity of the robot and before the mowing season, it is necessary to perform a series of operations to
guarantee the correct functioning at the time of reuse.
1. Fully charge the battery before winter storage. Recharge the battery at least once every five months.
2. Have the routine maintenance performed by an authorised dealer. This is essential for keeping the robot in good condition.
The assistance service usually includes the following operations:
•
total cleaning of the robot, the cutting blade and all the other moving parts.
•
cleaning of the inside of the robot.
•
checking of robot functioning.
•
checking and, if necessary, replacement of any worn parts such as the cutting blade.
•
checking of the battery capacity.
•
if necessary, the dealer may also load new software.
3. Accurately clean the robot (see "Robot Cleaning").
4. Check any worn or damaged components such as the cutting blade and evaluate their replacement.
5. Store the robot in a protected and dry place with an ambient temperature between 10° and 20° C, out of reach of foreign
elements (children, animals, other foreign objects, etc.). Store the robot at a temperature below 20°C in order reduce the
automatic discharge of the batteries.
6. Disconnect the power plug from the power supply unit.

ROBOT STOP

PROLONGED INACTIVITY AND RESTARTING

(A)
(D)
21
(C)
P LAY
PAU SE
STOP
OF F
(B)
ON
User's manual
EN