Adjusting Projected Images
Correcting Distortion in the Projected Image
You can correct keystone distortion in projected images using one of the
following methods.
• H/V-Keystone
Correct distortion in the horizontal and vertical directions independently.
"H/V-Keystone"
p.55
s
• Quick Corner
Correct the four corners independently.
"Quick Corner"
p.57
s
• Arc Correction
Corrects distortion that occurs when projecting on a curved surface.
"Arc Correction"
p.58
s
a
• By pressing the [Geometry] button on the remote control or the
[
] button on the control panel, you can perform the selected
adjustment method directly.
• When you want to re-adjust the projection position and so on, if
you want to release the correction status temporarily, set the
Geometry Correction to Off. Even when it is set to Off, the
correction values are saved.
s Settings - Geometry Correction
• You cannot combine multiple adjustment methods.
H/V-Keystone
This allows you to correct distortion in the horizontal and vertical
directions independently. Distortion can be corrected when the angle of
vertical and horizontal tilt of the projector is up to 30 degrees against the
screen.
a
Press the [Menu] button while projecting.
b
Select Geometry Correction from Settings.
55
p.121