Connecting An Hdbaset Transmitter (Eb-5535U/Eb-5530U/Eb-5520W Only) - Epson EB-5535U User Manual

Connecting Equipment

Connecting an HDBaseT Transmitter (EB-5535U/EB-5530U/EB-5520W only)

Connect the optional HDBaseT Transmitter with a commercially available 100BASE-TX LAN cable.
"Optional Accessories" p.203
s
a
• Make sure you read the User's Guide supplied with the HDBaseT Transmitter carefully before use.
• For the LAN cable, use an HDBaseT Alliance-recommended STP cable (straight) of category 5e or higher. However, operation is not guaranteed for all
input/output devices and environments.
• When connecting or disconnecting the LAN cable, make sure you turn off the power for the projector and the HDBaseT Transmitter.
• When performing Ethernet communication or serial communication, or when using the wired remote control via HDBaseT port, set Control Communications
to On from the Configuration menu.
s Extended - HDBaseT - Control Communications
Note that when Control Communications is set to On, the projector's LAN port, RS-232C port, and Remote port are disabled.
• When using the Extron XTP transmitter or switcher, connect to the projector's HDBaseT port. Set Extron XTP to On (Standby Mode and Control
Communications are automatically set to On).
s Extended - HDBaseT - Extron XTP
HDBaseT
p.122
p.122
43