Communications Configuration; Additional Configuration - Siemens BT300 Operator's Manual

Start-up Procedures

Communications Configuration

Step Parameter/Question
6 Command Source (P3.5.1.1)
7 Interlock* (P3.2.11)
Step Parameter/Question
8 Interlock Delay (P3.2.12)
9 Auto Bypass* (P3.18.2)
Step Parameter/Question
10 Auto Bypass Delay (P3.18.4)
11 Fault Selection (P3.18.3)
Communications Configuration

Additional Configuration

22
Siemens Industry, Inc.
If Enabled is selected for Remote Bypass, Step 6 displays. Otherwise, the wizard
jumps directly to Step 7.
If Enabled is selected for Interlock, Step 8 displays. Otherwise, the wizard jumps
directly to Step 9.
If Enabled is selected for Auto Bypass, Step 10 displays. Otherwise, the wizard jumps
directly to Step 11.
* Feature of the Electronic Bypass Option. For more details, see the Applications
Features (Electronic Bypass Only) section of this document.
The following message displays: Bypass Wizards is now complete. Press
OK to continue. The Bypass Wizard is now complete. Any site specific application
programming should now be completed.
The communications configuration is documented in the Siemens BT300 HVAC Drive
Operator's Manual (DPD01809).
Depending upon the site and the sequence of operation desired, such as auto reset,
flying start, skip frequencies, and switching frequency, additional configuration may be
required. See the Siemens BT300 HVAC Drive Operator's Manual (DPD01809). for
further configuration information.
BT300 Bypass Operator's Manual
Settings
Fieldbus CTRL
I/O Control
Enabled
Disabled
Settings
Range: 0 to 120 s
Enabled
Disabled
Settings
Range: 0 to 30 s
Select faults to enable Auto Bypass:
Any Fault
Undervoltage
Overvoltage
Overcurrent
AI Low
Unit Temperature
Motor Overtemp
External Fault
Underload Fault
DPD01391
2016-08-05