Allen-Bradley SLC 500 Quick Start Manual page 60

5–16 Using RS232-to-Ethernet Channel-to-Channel Passthru
Publication 1747-10.4
Passthru Routing Table
The passthru routing table is located under the channel configuration
selection in RSLogix500 Programming Software. If a Passthru
Routing Table File number was entered in the General Tab in the
Channel Configuration dialog box, click on the + in front of
"Channel Configuration" to reveal the routing table selection.
Double-click on "Routing Table" to view and modify the routing
table.
Important: The routing table must contain the IP address of the
SLC 5/05 #2 at station target node three, as shown in
the routing table above. Target node three was
identified as the target node in the SLC 5/03 Message
Setup dialog box.