Table of Contents
Advertisement
Available languages
Available languages
en | 8 | Installation and Operating Instructions | Power Max Level 2 Charging Station
4
Installation
4.1
Important SAFETY WARNINGS and Instructions
IMPORTANT SAFETY INSTRUCTIONS. SAVE THESE INSTRUCTIONS.
WARNING
Danger of electrical shock or injury. Turn OFF power at the panelboard or load center before working
inside the equipment or removing any component . Do not remove circuit protective devices or any
other component until the power is turned OFF.
The Power Max Level 2 Charging Station should be installed only by a licensed contractor, and/or a licensed
electrician or trained installation expert in accordance with all applicable state, local and national electrical codes
and standards.
Before installing the Power Max Level 2 Charging Station, review this manual carefully and consult with a licensed
contractor, licensed electrician, or trained installation expert to ensure compliance with local building practices,
climate conditions, safety standards, and state and local codes.
The Power Max Level 2 Charging Station is to be hardwired only. The installation of a plug is not allowed.
4.2
Grounding Instructions
This product must be connected to a grounded, metal, permanent wiring system; or an equipment grounding con-
ductor must be run with the circuit conductors and connected to the equipment grounding terminal or lead on the
product.
4.3
Recommended Tools
The following tools are recommended for the Power Max Level 2 Charging Station installation:
Supplied accessories and components:
}
–
Level 2 Charging Station mounting bracket
–
Three (3) Torx T30 screws for securing the Level 2 Charging Station to the mounting bracket
Installer-supplied components:
}
–
Conduit of appropriate trade size for power wire
–
Two (2) screws for securing the main body mounting bracket to the wall
Recommended tools:
}
–
Torx T30 screwdriver
569217 | REV. D | 09.08.2016
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
