How To Connect Speaker - Inter-m PMU-240NA Operation Manual

How to connect speaker

How to connect speaker
1) After disconnecting power code from the power outlet, connect the using speaker to the speaker connector at
the backside panel as below.
- If using High-Z speaker
※ If using High-Z speaker, setup AMp mode to 100V(or 70V).
※ If using High-Z speaker, you can use both SWITCHeD connector and UnSWITCHeD/lo-Z connector,
in this case, be cautious to not connect low-Z speaker to UnSWITCHeD/lo-Z connector.
- If using low-Z speaker
※ If using low-Z speaker, make sure you setup the AMp mode to low-Z.
※ If using low-Z speaker, only connect speaker to UnSWITCHeD/lo-Z connector, and you can't use
SWITCHeD connector. (regardless of any speaker select switch, UnSWITCHeD/lo-Z connector
always output.)
2) Minimize master volume, and start the device.
※ for more information about setup, note lCD main page > 5) SeTUp > ⑥ AMp description.
3) Connect speaker accordingly to the AMp mode that is setup in pMU-nA.
4) Use front speaker select switch to select speaker output region.
5) Use front volume to rightly control broadcasting volume.
MIxIng AMplIfIer
pMU-240nA/600nA 39