Fig. - Kicker PF150S11 Assembly Manual

31. Pull the air bag assembly out approximately three inches to gain access to the screw securing the top of
the right vent assembly and remove the screw. Place a towel under the airbag assembly to prevent it from
scratching the dash. Fig. 19
32. Pull the right vent assembly loose and disconnect wiring.
33. Remove the four screws securing the pocket below the radio. Fig. 20
Power Wire Routing
36. Find the fuse box in the engine compartment and open the cover.
37. Remove the nut on the accessory lug, connect the power wires and retighten the nut. Torque to 9Nm.

Fig. 22

38. Route the power wires across the radiator support and toward the grommet on the driver's side of the
fi rewall. Secure with supplied wire ties. Fig. 23
Connect
Power Wire
Here
Secure
Harness
Here
Place your warranty card in the glove box for future use.
6
Fig. 19
34. Pull loose the radio bezel and pocket assembly and
disconnect wiring. Fig. 21
35. Remove the four screws securing the radio, remove radio and
disconnect wiring.
Fig. 21
Fig. 22
Fig. 20
Grommet
for amp
i
Fig. 23