Fig. - Kicker PF150S11 Assembly Manual

Subwoofer Installation
68. Connect the subwoofer harness to the subwoofer. Pull any slack in the harness toward the door
opening and secure any excess harness to the factory wiring along the door opening with supplied wire ties.
69. Install the supplied M6 speed clips over the holes in the seat frame that correspond to the holes in the
subwoofer mounting brackets.
70. Line the bracket up with the holes in the seat frame and secure with the supplied M6. Fig. 36
71. Install the supplied decal over the bolt on the back of the subwoofer enclosure.
72. Install fuses into fuse holder.
73. Reinstall all previously remove parts in reverse order.
74. Reconnect negative battery cable.
Troubleshooting the Kicker Integrated Systems
If you experience a problem once the Subwoofer is installed use this guide to locate the trouble.
The radio is working, but the Subwoofer is not working:
• Check the battery voltage to make sure it is not discharged below 11 volts.
• Check the negative battery cable to see if it has been securely tightened back on the battery.
• Check the inline fuse located near the battery to make sure it is plugged in completely, and not blown.
• Check the inline +12Volt power-connector near the fi rewall to make sure it is plugged in securely.
• Check the inline connectors near the subwoofer enclosure to make sure they are plugged securely.
• Check the ground wire connection to make sure it is tightly secured to the proper ground in the vehicle.
• Check the audio input signal connection to make sure it is secure and connected to the proper wiring.
• Test with different music in case there is no low frequency audio in the initial sound check.
There is a buzz or rattle noise that accompanies the low frequency element of the music:
• Check for a connector or any other object that could be very near the enclosure.
• Check the subwoofer enclosure mounting brackets to make sure they are secure.
10

Fig. 36