Download Print this page

Kicker PSIEXT07 Manual

2007 - 2013 chevrolet silverado & gmc sierra ext-cab 1500 series with base radio; 2007 - 2014 chevrolet silverado & gmc sierra ext-cab 2500/3500 series with base radio

Advertisement

Quick Links

2007 - 2013 Chevrolet® Silverado & GMC® Sierra Ext-Cab 1500 series with base radio
2007 - 2014 Chevrolet® Silverado & GMC® Sierra Ext-Cab 2500/3500 series with base radio
(Not compatible with vehicles equipped with the full-width rear bench seat)
Subwoofer
Power Harness
25A Fuse
Wire Ties x6
Subwoofer Body
Harness
©2012 Stillwater Designs
PSIEXT07-A4-20160202
PSIEXT07
Designed for
(Not Compatible with Bose® Audio)
Subwoofer Assembly
1

Advertisement

loading

Summary of Contents for Kicker PSIEXT07

  • Page 1 PSIEXT07 Designed for 2007 - 2013 Chevrolet® Silverado & GMC® Sierra Ext-Cab 1500 series with base radio 2007 - 2014 Chevrolet® Silverado & GMC® Sierra Ext-Cab 2500/3500 series with base radio (Not compatible with vehicles equipped with the full-width rear bench seat) (Not Compatible with Bose®...
  • Page 2 Amplifi er Assembly Amplifi er Body Harness Amplifi er Power Harness M6 Bolt 25A Fuse Wire Ties x6 Amplifi er Wire Routing 1. Disconnect the negative battery cable from the battery. (For diesel engines with dual batteries disconnect both negative cables) 2.
  • Page 3 6. Pull loose the radio bezel and disconnect wiring. Fig. 3 7. Remove the six screws securing the radio and HVAC controls. HVAC control wiring does not need to be disconnected. Fig. 4 Fig. 3 8. Pull radio from dash and disconnect all wiring. 9.
  • Page 4 Remove wire retainer from this Fig. 7 Fig. 8 hole 16. Connect the amplifi er harness to the amplifi er. 17. Align the upper hole and speed clip of the amplifi er bracket with the hole that was used for the wire retainer.
  • Page 5 21. Remove the plastic cover over the power distribution center on the passenger’s side of the fi rewall near the battery. Not available on some vehicles. If this is the case, proceed to step 23. 22. Remove the fuse from the fuse holder on the amplifi er power wire and connect the power wires to the accessory lug.
  • Page 6 37. Reinstall all previously removed parts in reverse order. 38. Reconnect negative battery cable. Torque to 17Nm. Troubleshooting the Kicker Integrated Systems If you experience a problem once the Subwoofer is installed use this guide to locate the trouble. The radio is working, but the Subwoofer is not working: •...
  • Page 7 • Check for a connector or any other object that could be very near the enclosure. • Check the subwoofer enclosure mounting brackets to make sure they are secure. There is a problem with the multi-channel stereo amplifi er: • Check the battery voltage to make sure it is not discharged below 11 volts. •...
  • Page 8 If you continue to experience problems after troubleshooting, please contact KICKER Technical Support at (800) 256-0808 ext. 6009, or support@kicker.com. stillwater designs P.O. Box 459 • Stillwater, Oklahoma 74076 • USA • (405) 624–8510...