Enabling And Disabling Parksense; Service The Parksense Rear Park Assist System - Jeep CHEROKEE 2017 Owner's Manual

NOTE: ParkSense will reduce the volume of the radio, if
on, when the system is sounding an audio tone.

Enabling And Disabling ParkSense

ParkSense can be enabled and disabled with the ParkSense
switch, located on the switch panel below the Uconnect
display.
ParkSense Switch
When the ParkSense switch is pushed to disable the
system, the instrument cluster display will show the
"PARKSENSE OFF" message for approximately five sec-
onds. Refer to "Instrument Cluster Display" in "Getting To
Know Your Instrument Panel" for further information.
When the gear selector is moved to REVERSE and the
system is disabled, the instrument cluster display will
show the "PARKSENSE OFF" message for as long as the
vehicle is in REVERSE.
The ParkSense switch LED will be on when ParkSense is
disabled or requires service. The ParkSense switch LED
will be off when the system is enabled. If the ParkSense
switch is pushed, and requires service, the ParkSense
switch LED will blink momentarily, and then the LED will
be on.

Service The ParkSense Rear Park Assist System

During vehicle start up, when the ParkSense Rear Park
Assist System has detected a faulted condition, the instru-
ment cluster display will actuate a single chime, once per
ignition cycle, and it will display the "PARKSENSE UN-
AVAILABLE WIPE REAR SENSORS" or the "PARKSENSE
UNAVAILABLE SERVICE REQUIRED" message. Refer to
"Instrument Cluster Display". When the gear selector is
moved to REVERSE and the system has detected a faulted
condition, the instrument cluster display will show the
PARKSENSE UNAVAILABLE WIPE REAR SENSORS or
PARKSENSE UNAVAILABLE SERVICE REQUIRED mes-
sage for as long as the vehicle is in REVERSE. Under this
condition, ParkSense will not operate.
STARTING AND OPERATING 311
6