Engine Installation; Engine Installation Overview; Aircraft Where Io-360-N1A Engines Can Be Installed; Aircraft Where Io-360-N1A Engines Cannot Be Installed - Lycoming IO-360-N1A Installation And Operation Manual

IO-360-N1A Engine Installation and Operation Manual

Engine Installation Overview

The installation instructions in this manual are basic guidelines. When installing the engine in the
airframe, follow the airframe manufacturer's installation instructions.
NOTICE: All requirements identified in the chapter "Requirements for Engine Installation" must
be completed before engine installation.
This engine can be installed in aircraft in Table 1.

Aircraft Where IO-360-N1A Engines Can Be Installed

FAR Part 23 normal and utility category aircraft up to Class III
NOTICE: This engine cannot be installed in aircraft in Table 2.

Aircraft Where IO-360-N1A Engines Cannot Be Installed

Any FAR Part 25 aircraft
Any FAR Part 29 rotorcraft
NOTICE: Installation drawings for this engine are available for purchase from Lycoming Engines.
Refer to Appendix B for ordering information.
To install the engine, refer to the section reference in this chapter for each step in Table 3.
Step Section References in This Chapter
1 Install the Engine on Mounts
2 Connect the Wiring Harness
3 Connect the Linkages
4 Install External Accessories (as necessary)
5 Install Baffling
6 Install the Compressor Belt (as necessary)
7 Install the Propeller
8 Connect Fuel Lines
9 Connect Oil Lines
10 Install Components That Had Been Removed Before Engine Installation
11 Add Oil
12 Add Fuel (to aircraft as necessary)
13 Engine Pre-Oil Procedure
© 2016 Avco Corporation. All Rights Reserved
February 2016

ENGINE INSTALLATION

Table 1
Table 2
Table 3

Engine Installation Steps and References

Engine Installation
Page 17