Engine Preservative Oil Removal; Lift The Engine - Lycoming IO-360-N1A Installation And Operation Manual

Engine Preservative Oil Removal

The engine is sent with preservative oil in the cylinder and preservative oil in the crankcase. Refer to
the "Prepare a New, Rebuilt, or Overhauled Engine for Installation" section in the "Requirements for
Engine Installation" chapter in this manual.

Lift the Engine

THE HOIST MUST HAVE A CAPACITY TO LIFT A MINIMUM OF 750 LB
(340 KG).
WHEN LIFTING THE ENGINE, USE CARE TO PREVENT THE
PRESERVATIVE OIL FROM SPLASHING ON OTHER ENGINE PARTS.
1. Connect the hoist and chains to the lifting lug on the engine as shown in Figure 2.
MAKE SURE THE AREA IS CLEAR WHEN LIFTING THE ENGINE. DO
NOT LIFT FROM THE FRONT, REAR, SIDES OR BOTTOM OF THE
ENGINE. DO NOT LET THE ENGINE HIT ANY OBJECTS TO PREVENT
DAMAGE TO THE ENGINE OR ITS COMPONENTS.
2. Lift the engine slowly and vertically.
3. When the engine has preservative oil, complete the preservative oil removal procedure now
while the engine is lifted. Refer to the section "Prepare a New, Rebuilt, or Overhauled Engine for
Installation" section or "Prepare a Stored Engine for Installation" in the "Requirements for
Engine Installation" chapter in this manual.
Engine Reception and Lift
Page 8
IO-360-N1A Engine Installation and Operation Manual
Figure 2
Engine Lift
© 2016 Avco Corporation. All Rights Reserved
February 2016