Note On Body Temperature - Innovo INV-DC200 Instruction Manual

☆ Batteries should be installed according to the stated polarities.
Otherwise, the device bracket might be damaged.
☆ Please remove the batteries if you will not be using the thermometer
for an extended period of time.
4.

Note on Body Temperature

 The normal body temperature is a range.
 The normal range varies from person to person and can fluctuate
throughout the day.
 The normal range also varies by body site. Therefore, measurements
from different sites should not be compared directly.
It is advised to know each individual's normal body temperature when
they are well. Also note the specific body site measured, ie: forehead or
eardrum. Take multiple readings to get a normal range. This will help in
determining if a sick individual is experiencing elevated body temperature
and/or having a fever.
Body Site Normal Temperature Range
Forehead 94.5°F- 99.1°F
Eardrum
96.4°F-100.4°F
Mouth
95.9°F- 99.5°F
Armpit 94.5°F- 99.1°F
Rectal
97.9°F-100.4°F
* The normal body temperature range varies slightly with age and gender.
Generally, newborns or children have higher body temperatures than
adults, and adults have higher body temperatures than the elderly.
Women's body temperatures are approximately 0.3°C (0.5 °F) higher
than men's.
(34.7°C-37.3°C)
(35.8°C-38.0°C)
(35.5°C-37.5°C)
(34.7°C-37.3°C)
(36.6°C-38.0°C)
5
The measured value falls below
89.6°F/32°C.
Inquiry for memory data, Storing 20 temperature
readings
LCD Operational method and instruction for
display displays
Press and hold button F2 for 3-6 seconds
and the LCD will display "- - -" with the M
signal blinking.
Press button F2 again and the LCD will
display the number '1' with the M signal. After
1 second, the measured temperature with
the mode of measurement icon will be
displayed. Note that this is the latest reading.
To recall the next recorded reading, press
button F2 again. The number '2' with the M
signal will be displayed. After 1 second, the
measured temperature with the mode of
measurement icon will be displayed.
Repeat to recall earlier recordings (up to 20
total) if necessary.
The LCD will display "- - -" with the M signal
blinking if there is no test data.
°C/°F conversion
LCD Operational steps
display
When the thermometer is off, press and hold
the F2 button for 6-9 seconds. The screen
will display "- - - " with "M" at the bottom right.
Continue to hold the button until "- - -°C/°F"
appears on the screen. Release the F2
button and the "- - -°C/°F" temperature unit
will start to blink. Press the F2 button again
3 short beeps with a red
backlit for 3 seconds.
Sound and
backlit
None
None
None
Sound and
backlit
None
10