Care And Cleaning - Innovo INV-DC200 Instruction Manual

 The thermometer is not waterproof. Do not immerse in water or other
liquids. For cleaning and disinfecting, please follow instructions in the
'Care and Cleaning' section.
 Certain parts of the thermometer are lined precisely in order to
perform properly. Do not drop the thermometer or twist the
thermometer sensor. The thermometer is not designed to withstand
intense impact or vibration.
 The thermometer is not a toy. Please keep out of children's reach.
 Do not touch the tip of the thermometer probe. This may damage
the infrared sensor inside.
3.

Care and Cleaning

CAUTION! The thermometer sensor is extremely sensitive. The
sensor lens has to be perfectly clean to ensure accurate readings.
CAUTION! Any debris and/or facial oil on the sensor lens will
prevent an accurate measurement. Always check the sensor before
use. The lens should be reflective and gleaming. If it looks dull and
lackluster, please clean the lens before use.
 To clean the lens, gently swab the surface with a cotton swab
moistened with rubbing alcohol (70% Isopropyl). Do not exert too much
pressure as it may damage the delicate sensor.
 Wait for the alcohol to evaporate completely before using the
thermometer. This may take about 5-10 minutes. Any residual alcohol
will prevent accurate readings.
 To clean the thermometer body and display, wipe with a soft cloth
slightly moistened with water or rubbing alcohol. Allow to air dry or
gently dry with a piece of tissue paper.
Temperature taking tips for accurate measurement
 Always start with a clean probe and sensor to maintain accuracy and
3
9. Troubleshooting
Symptom Possible Cause
The battery level is
extremely low.
Polarities of the
The batteries are
thermometer reversed.
fails to power on.
The thermometer is
faulty.
Battery symbol The battery level is
displayed when low.
thermometer
powers on.
The ambient
temperature is lower
"Er1" is
than 10°C (50°F) or
displayed.
higher than 40°C
(104°F).
The infrared sensor
is dirty.
The temperature
reading is lower
than the typical
The thermometer
body
probe is not aligned
temperature
to the eardrum.
range.
The thermometer is
used within 30
minutes after being
taken from a cold
Solution
Use new batteries of the
same model or
specifications.
Ensure that the batteries
are correctly installed
according to the polarity
symbols in the battery
compartment.
If the warranty period has
not expired, contact the
manufacturer.
Use new batteries of the
same model or
specifications.
Take a measurement under
an ambient temperature
between 10°C (50°F) and
40°C (104°F).
Clean the sensor using a
cotton swab moistened with
alcohol. The sensor surface
should be reflective and
gleaming.
Reposition the
thermometer probe so that
it is aligned to the eardrum.
Wait for 30 minutes before
taking the temperature
again
12