Balance White Auto; Lut; Lut Mode - IAI GO-5000M-USB User Manual

There are three modes.
OFF:
Continuous:
The following detailed settings are also available.
ALC Speed:
Gain Auto Max:
Gain Auto Min:
ALC Reference:
ALC Area Selector:
ALC Area Enable:
9.2.5

Balance White Auto

This is a function to achieve auto white balance by using R and B gain.
There are three methods which can be selected.
OFF:
Once:
Continuous:
AWB Channel Area: AWB reference areas can be selected from 16 (4x4) choices.
Note: The figure for AWB Channel Area is the same as Fig.31.
9.3.

LUT

This function can be used to convert the input to the desired output characteristics.
The Look-Up Table (LUT) has 32 points (Monochrome) or 16 points (Bayer color) for setup. The
output level can be created by multiplying the gain data by the input level.
9.3.1

LUT Mode

Can be set to OFF, gamma (see section 9.4), or Lookup Table.
GO-5000M-USB / GO-5000C-USB
Adjust manually.
Operate the auto gain continuously
The rate of adjustment of GainAuto can be set (Common with
ExposureAuto).
The maximum value of GainAuto control range can be set
The minimum value of GainAuto control range can be set
The reference level of Gain Auto control can be set (Common
with ExposureAuto)
The portion of the image used for auto gain control can be set
(Common with ExposureAuto）
This command can make selected area(s) disabled or enabled.
If ALC Area Selector selects ALC Area Enable ALL, and it is set
to True, all areas are enabled and in this case, preset areas are
all disabled.
High High
High
Mid-left Mid-right
Left
Mid-High
Mid-High Mid-High
Left
Mid-left Mid-right
Mid-Low Mid-Low
Mid-Low
Mid-left Mid-right
Left
Low
Low
Low
Mid-left
Mid-right
Left
Fig.32 ALC Channel Area
Manual operation
The auto white balance is executed one time when this command is
set.
The auto white balance is continuously executed.
- 53 -
High
Right
Mid-High
Right
Mid-
Low
Right
Low
Right