Displays In Partitioning Master Mode - GE NX-148E User Manual

Displays in partitioning master mode

ARMED AND READY STATUS
The LCD screen will display the Armed and Ready status of ALL eight (8) partitions if any or all of the
areas is armed or not ready.
Armed
Ready
System Ready
Type code to arm
ARMING AND DISARMING MULTIPLE PARTITIONS
To arm/disarm multiple partitions, enter a code that has arm/disarm authority for ALL of the partitions
to be armed/disarmed. The following display will appear on the LCD screen.
1 2 - 4 5 - 7 8
- - 3 - - 6 - -
Refer to the following table for possible conditions :
LCD DISPLAY FOR AREA
TOP LINE OVER BOTTOM LINE
Blank
Blank
Dash (-)
Dash (-)
Flashing Area #
Dash (-)
Dash (-)
Flashing Area #
Area #
Dash (-)
Dash (-)
Area #
•
To disarm all of these areas, press the [ ] up scroll key
•
To arm all of these areas, press the [ ] down scroll key
•
To toggle a single area between the armed and disarmed conditions, press [r][Area number].
For example: If Area 4 is armed, [r] [4] will disarm Area 4. If Area 4 is disarmed, [r] [4] will arm it.
•
Press [STAY] during the exit delay to bypass all interior zones in the exit delay.
•
To control the individual areas, refer to the following section.
NX-148E User manual
This display is reflecting all 8 areas are Ready, and Area 5 is
1234-678
disarmed. NOTE: If a number is flashing on the armed line,
12345678
that area is armed Instant. If a number is flashing on the
ready line, that area is ready to be Force Armed.
If ALL areas are disarmed and ready to arm, this display will
appear on the LCD screen.
The numbers on the top line represent the disarmed areas
Disarm
to which this code has access. The numbers on the bottom
Arm
line represent the areas that are armed.
CONDITION
Area Not used or Authorized
Area Not Ready
Area Ready to Force Arm
Area Armed Instant
Area Disarmed & Ready to Arm
Area is Armed
Page 21
g
GE Security
04/10/04