Appendix A – Event Log - GE NX-148E User Manual

APPENDIX A – EVENT LOG
NOTE: Your system may not have all of the features listed in this table.
DISPLAY DESCRIPTION
TXlobat Transmitter Low Battery
ZN Lost Zone Lost
Duress Duress
Man Fire Manual Fire
Aux 2 Auxiliary 2
Panic Panic
KP Tamper Keypad Tamper
BoxTamp Box Tamper
AC Fail AC Fail
OverCur Over Current
Srn Tamp Siren Tamper
Tel Flt Telephone Fault
Exp Trb Expansion Trouble
Log Full Log Full
Open Open
Close Close
Exit Err Exit Error
Rec Close Recent Close
Autotest Auto Test
Start Prog Start Programming
End Prog End Programming
Start Dnld Start Download
End Dnld End Download
Cancel Cancel
Gnd Flt Ground Fault
Man Test Manual Test
Re-exit Re-Exit
Output Trip Output Trip
Data Lost Data Lost
Walk-test Walk-Test
End Test End Test
Cross-Trip Cross Trip
Expansion Expansion Event
Event
Partial Arm Partial Arm
Listen In Listen In
Service Start Service Start
Service End Service End
Code Entry Code Entry
NX-148E User manual
The transmitter has a low battery.
A wireless or multiplexed zone device is not reporting to
the control.
The control has been armed or disarmed with a Duress
code.
Keypad "Fire" has been activated.
Keypad "Medical" has been activated.
Keypad "Panic" has been activated.
The keypad tamper has been activated.
The box tamper circuit has been activated.
AC failure has been detected.
A short circuit of a power supply has occurred.
A siren or speaker tamper has been detected.
A telephone fault or tamper has been detected.
An expansion device or keypad is not reporting to the
control.
The event log is full. Old events will be pushed out as new
ones enter the log.
Reports user number, date, time and partition of opening.
Reports user number, date, time and partition of closing.
Entry/Exit zone was faulted at the instant the exit delay
expired.
An alarm occurred within 5 minutes after the control was
armed.
Sending a communicator test at a specified interval.
Local programming is started.
Local programming is ended.
Download session is started.
Download session is ended.
System is disarmed and the Cancel button was pressed
within 5 minutes of an alarm.
A short to ground has been detected.
Bell and/or communicator test while system is in disarmed
condition.
The exit delay has been re-started without disarming the
system.
A trip has occurred on an expander auxiliary output.
Communication of a signal has failed (log only event).
A zone "Walk-Test" mode has been activated.
Test has been ended.
The first zone of a cross zone has been tripped (log only).
An expansion module created an undefined event.
Reports a closing in the stay mode.
A listen in function has been activated.
Technician is on site.
Technician is off site.
A code has been entered.
Page 26
g
GE Security
04/10/04