Keithley 2600a series Reference Manual page 645

Series 2600A System SourceMeter® Instruments Reference Manual
Table A-2 (cont.)
Error summary
Error number
4904
4905
4906
5001
5003
5004
5005
5007
5008
5009
5010
5011
5012
5013
5014
5015
5016
5017
5018
5019
5021
5022
5023
5024
5025
5027
5028
5029
5032
5033
5038
5040
5041
5042
5043
5044
5045
5046
5047
5048
5049
5050
5051
5052
5052
2600AS-901-01 Rev. B / September 2008
Error level Error Message
SERIOUS ICX parameter count mismatch, %s (Line #%d)
SERIOUS ICX parameter invalid value, %s (Line #%d)
SERIOUS ICX invalid function id, %s (Line #%d)
FATAL SMU is unresponsive
SERIOUS Saved calibration constants corrupted
SERIOUS Operation conflicts with CALA sense mode
SERIOUS Value too big for range
SERIOUS Operation would exceed safe operating area of the instrument
SERIOUS Operation not permitted while output is on
SERIOUS Unknown sourcing function
SERIOUS No such SMU function
SERIOUS Operation not permitted while cal is locked
SERIOUS Cal data not saved - save or restore before lock
SERIOUS Cannot save cal data - unlock before save
SERIOUS Cannot restore cal data - unlock before restore
SERIOUS Save to cal set disallowed
SERIOUS Cannot change cal date - unlock before operation
SERIOUS Cannot change cal constants - unlock before operation
SERIOUS Cal version inconsistency
SERIOUS Cannot unlock - invalid password
SERIOUS Cannot restore default calset. Using previous calset
SERIOUS Cannot restore previous calset. Using factory calset
SERIOUS Cannot restore factory calset. Using nominal calset
SERIOUS Cannot restore nominal calset. Using firmware defaults
SERIOUS Cannot set filtercount > 1 when measure.count > 1
SERIOUS Unlock cal data with factory password
SERIOUS Cannot perform requested operation while source auto-range is
enabled
SERIOUS Cannot save without changing cal date and cal due values
RECOVERABLE Cannot change this setting unless buffer is cleared
RECOVERABLE Reading buffer not found within device
RECOVERABLE Index exceeds maximum reading
RECOVERABLE Cannot use same reading buffer for multiple overlapped
measurements
SERIOUS Output Enable not asserted
SERIOUS Invalid while overlapped measure
SERIOUS Cannot perform requested operation while voltage measure auto-
range is enabled
SERIOUS Cannot perform requested operation while current measure auto-
range is enabled
SERIOUS Cannot perform requested operation while filter is enabled
SERIOUS SMU too hot
RECOVERABLE Minimum timestamp resolution is 1µs
SERIOUS Contact check not valid with HIGH-Z output off
SERIOUS Contact check not valid while an active current source
SERIOUS I limit too low for contact check
FATAL Model Number/SMU Hardware mismatch
RECOVERABLE Interlock engaged; system stabilizing
RECOVERABLE Cannot disable output enable action
Return to Section Topics
Appendix A: Error and Status Messages
A-5