Basic Operation - Dranetz hdpq xplorer User Manual

Basic Operation

Introduction
Battery pack
AC power
source
Shop for Power Metering products online at:
The normal power source for the HDPQ Xplorer is its internal battery pack. The AC
Adapter/Battery Charger is used to charge the battery. Always charge the battery fully
before use. HDPQ Xplorer will always operate on the charger and is designed to do so,
regardless of the state of charge of the battery.
Type: Sealed, rechargeable NiMH (Nickel Metal Hydride) cells.
Length of operation: HDPQ can operate on a fully charged battery pack for
approximately three (3) hours of continuous use.
Charging: The battery pack can be charged by connecting the AC Adapter/Battery
Charger to the HDPQ Xplorer. A screen warning will appear during operation when
battery charge is low. A depleted battery pack can be recharged in three (3) hours
whether the unit is on or off. While charging, the taskbar displays a battery icon
indicating the percent of battery charge.
HDPQ Xplorer can be operated from a 50/60 Hz 120/240V AC power source with or
without the battery pack installed.
Connect the AC Adapter output cable to the input connector on the left side of the unit.
Connect the AC Adapter to an appropriate outlet using the appropriate adapter plug.
Refer to Appendix C for the specifications and replacement of the batteries contained
in HDPQ Xplorer.
PowerMeterStore
www.
CH 1/ Getting Started
1-23
1.877.766.5412
.com