Waveform Capture - Dranetz hdpq xplorer User Manual

Waveform Capture

Trigger channel
setup
Shop for Power Metering products online at:
HDPQ
Xplorer allows you to set the trigger channels/parameters for waveform capture
to determine which channel's data will be saved when a trigger occurs.
Action...
STEP 1: From the Trigger Limits
Setup Options screen, press

Waveform Capture.

The checked fields show the
channels that will have
waveforms recorded should a
trigger occur. This cross-trigger
function minimizes recording of
meaningless data from unused
(disabled) channels, as well as
shows the effect that the triggered
event has on other active channels
that may have not triggered.
• Check/Uncheck a channel field
to enable/disable selections for
waveform capture. Refer to the
table next page for descriptions
of waveforms recorded for each
trigger channel selection.
• Finish - saves the changes
made and brings you back to
the trigger limits setup options
screen.
• Exit - prompts the Exit Setup
screen where you can either
Accept or Abort the monitoring
setups. Go to page 4-48.
PowerMeterStore
www.
CH 4/ Setup Monitoring
Result...
HDPQ-421
4-33
1.877.766.5412
.com