Tools Needed For Assembly; Unpacking Instructions - Fanimation Subtle Owner's Manual

This manual is designed to make it as easy as possible for you
to assemble, install, operate, and maintain your ceiling fan

Tools Needed for Assembly

blade screwdriver
WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 11). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
steps have been completed and will be helpful in finding your place should you be interrupted.
WARNING
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
your retail store for missing or damaged parts.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration.
Hanger Bracket
Assembly
Downrod/
Hanger Ball
Assembly
Canopy Screw
Cover
Motor Coupling
Cover
Four wire connectors
(supplied)

Unpacking Instructions

Ceiling Canopy
Motor
Assembly
LED Assembly
Materials
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
Installed Wire Length
Up to 50 ft.
50 - 100 ft.
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are missing,
contact your local retailer.
• Hanger Bracket Assembly
• Downrod/Hanger Ball
Assembly
• Ceiling Canopy
• Canopy Screw Cover
• Motor Coupling Cover
• Motor Assembly
• Light Plate/Glass Assembly
• LED Assembly
• Steel Cap
• Blade Set
• Hand-held Remote
• Receiver Unit
Light Plate/Glass Assembly
Steel Cap
4
Wire Size A.W.G.
14
12
• Hardware bags:
– #8-32 (blade to to fan motor hub)
washer head screw screws &
fiber washers
– Phillips Screwdriver, 4˝
– Balance Kit
Receiver
Hand-held Remote
Unit
Hardware Bags
Blade Set