Tools Needed For Assembly; Unpacking Instructions - Fanimation The Levon FP7910 series Owner's Manual

This manual is sesigned to make it as easy as possible for you
to assemble, install, operate, and maintain your ceiling fan

Tools Needed for Assembly

• One Phillips head screwdriver
• One stepladder
• One ¼˝ blade screwdriver
WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 9). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
For your convenience, check-of f each step. As each step is completed, place a check mark.
steps have been completed and will be helpful in f nding your place should you be interrupted.
WARNING
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
your retail store for missing or damaged parts.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration. (Figure 1, page 13)
Hanger Bracket
Fan Motor Assembly
NOTE: The illustration shown is not to scale or its
actual con guration or nishes may vary
• One wire stripper
• Three wire connectors
(supplied)

Unpacking Instructions

Downrod/
Hanger Ball
Ceiling Canopy
Assembly
Motor Coupling Cover
Switch Cup Housing/
Adapter Assembly
Materials
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
Installed Wire Length
Up to 50 ft.
50 - 100 ft.
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are missing,
contact your local retailer.
• Fan Motor Assembly
• Switch Cup/Adapter
Assembly
• Downrod/Hanger Ball
Assembly
• Hanger Bracket
• Ceiling Canopy
• Motor Coupling Cover
• Blade Holder Set
• Blade Set
3
Wire Size A.W.G.
14
12
This will ensure that all
• Hardware bags:
– 1/4˝-20 screws with lockwashers
(blade holder to fan motor hub)
– 3/16˝-24 carriage head nut
– 3/16˝-24 screws & flat washers
(blade to bladeholder)
– Phillips screwdriver, 4˝
– Two 5/32˝ threaded rods
– Two 5/32˝ lockwashers
– Two knurled knobs
– Ceiling support cable with clamp
– Flat washer
– Lag bolt
– Four wire connectors
– Chain coupler & chain fob
– Balance Kit
Hardware Bags
Blade Holder Set
Blade Set