SSD (M.2)
Description
M.2 SATA SSD, PCIe NVMe TLC
●
128 GB 2280 M2 SATA-3 Value PA
●
256 GB 2280 M2 PCIe 3x4SS NVMe TLC PA, for use with non-touch screen products
●
512 GB 2280 M2 PCIe 3x4SS NVMe TLC PA, for use with non-touch screen products
Before removing the SSD, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the following components:
a.
Battery (see
b.
Optical drive (see
c.
Base enclosure (see
Remove the SSD:
1.
Remove the Phillips M2.0 x 2.5 screw (1) that secures the SSD to the system board.
2.
Remove the SSD (2) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the SSD.
Battery on page
30)
Optical drive on page
Base enclosure on page
31)
33)
Component replacement procedures
Spare part number
827560-026
847109-002
847110-004
37