Care Instructions - Gardena RP 300 Operating Instructions Manual

G

Care Instructions

Take care that the pump is always completely submerged in water.
A lack of water can cause the feed impeller to turn in the wrong
direction.
➔ Remedy :
Disconnect the plug transformer and fill the pump with water.
Then connect the plug again.
Cleaning the filter The filter should be completely clean!
How to clean :
Pull out the plug transformer!
.
Clean the pump and the filter with a water jet.
.
Dismantle (and re-assemble afterwards) casing fittings and
.
clean the fittings inside carefully with water as described in the
paragraph "Dismantling ".
Information: Do not use any hard objects or strong detergents!
Blocked feed impeller If the feed impeller becomes blocked, the pump should be cleaned
(see paragraph on "dismantling").
22 22
Dismantling
Pull out the plug transformer!
.
Remove the pump from the water.
.
Dismantle the casing fittings as follows:
.
1. Pull down and remove the filter.
2. Push away the pump casing from the motor casing at the
pressure joint.
3. Pull the feed impeller out of the motor casing.
4. If necessary remove the volume control be moving it forwards.
Afterwards re-assemble the fittings reversing the order and
.
direction in which they were dismantled.
Storage
Where to store The pump should be stored out of the reach of children.
A
1. Take the pump out of the water and store away from frost
before the first frost sets in.
2. Clean and check the pump carefully.
3. Store the pump in a container filled with water.
The mains plug must not be submerged.
G
23