Operation - Gardena RP 300 Operating Instructions Manual

G
Check line voltage Check line voltage. Data indicated on the type plate must match
technical data of the mains supply.
Do not operate pump The pump must not be operated when there are people in the
when people are in water
water.
Do not use power cable Do not use the power cable to carry the pump or to pull the
to carry the pump plug. Protect the power cable from heat, oil and sharp edges.
Disconnect plug Please unplug the pump after operation and before carrying out
any maintenance works.
Temperature of the liquid The temperature of the liquid used must not be below 4 °C or
used above 35 °C.
Wear and reduced Sand and other abrasive substances in the liquid cause in-
output creased wear and reduce the output of the pump.
Caution !
GARDENA pumps and plug connections have been designed
9 V low voltage
exclusively for the use with 9 V low voltage. When connected
to 230 V your life is at risk! Operate the pump only with the
delivered transformer.
Do not expose the Do not expose the transformer to direct sunlight.
transformer to sunlight
18

Operation

Installing the pump Before operation submerge the pump in the water. Take care that
the pump is positioned in a way that the casing is completely
immersed in water.
The foam filter at the bottom must not be covered up at the
A
side!
Caution : Submersion depth Please note the maximum submersion depth (see "Technical Data").
Switching on the pump Put the plug of the pump into the socket of the mains plug and
then the mains plug into a 230 V AC socket.
Caution! Pump will start immediately.
Volume regulator Adjust the volume according to your needs by turning the volume
control. (➔ Turning anti-clockwise increases the volume)
G
19