The HMI display indicates:
5.2 START-UP
This section describes the power-up of the inverter with HMI operation, using the minimum
connections of
figure 3.1
of control will be considered: V/f control (scalar) and vector control V V W. For further details on
the utilization of these types of control refer to the CFW100 programming manual.
DANGER!
High voltages can be present, even after the disconnection of the power supply.
Wait at least 10 minutes for full discharge.
Figure 5.1: HMI Display when powering up
and without connections in the control terminals. Furthermore, two types
First Time Power-Up and Start-Up
CFW100 | 27