Operating Modes Of The Hmi - WEG CFW100 User Manual

Keypad (HMI) and Basic Programming

4.3 OPERATING MODES OF THE HMI

When energizing the inverter, the initial state of the keypad remains in the start-up mode as long
as there is no fault, alarm, undervoltage or any key is pressed.
The parameterization mode is composed of two levels: level 1 allows the navigation through the
parameters. And level 2 allows the edition of the parameter selected at level 1. At the end of this
level the modified value is saved when the key
Figure 4.3 illustrates the basic navigation of the operating modes of the HMI.
„
It is the initial state of the HMI after its successful
power-up (without the occurrence of faults, alarms or
undervoltage).
„ Press key to go to level 1 of the parameterization
mode – selection of parameters. Pressing any other key
also switches to parameterization mode.
Level 1:
„ This is the first level of the parameterization mode.
The parameter number is shown on the main display.
„
Use keys and
„ Press key to go to level 2 of the parameterization
mode – change of the parameter values.
Level 2:
„ O The parameter value is shown on the main display.
„
Use keys and
selected parameter.
„
Press key to confirm the modification (save the
new value). After confirming the modification, the HMI
returns to level 1 of the parameterization mode.
24 | CFW100
Initialization Mode
Parameterization Mode
to find the desired parameter.
to set the new value in the
Figure 4.3: HMI operating modes
is pressed.
Monitoring
Parameterization
Level 1
Parameterization
Level 2