2. Arm an Area with a Code
ACTION
Press
Enter the AREA # to arm.
Enter your ID #.
Enter your CODE #.
NOTE 1: If a device is at fault, the control center displays the fault.
Consult the "REFERENCE GUIDE" section for a description of the message.
If the user is able to correct the source of the fault, the arming procedure
resumes. If the fault is not corrected, the user may decide to force arm the
AREA by acknowledging the fault—if this option was enabled. Refer to the
"FORCE ARMING" section.
The system records which user has force armed the AREA.
NOW EXIT THE PREMISES
12
MESSAGE
AREA ? –
ID ? – –
ID ? # #
CODE ? – – – –
1—SYSTEM TEST
REQUEST ACCEPTED
AREA 1 ARMED
SIGNAL
2 BEEPS
2 BEEPS
ACKNOWLEDGE
TONE THEN EXIT
DELAY BEEP TONE
STARTS