Table of Contents
Advertisement
Power interruption
When using the heat gun, and the mains power is
interrupted, the heat gun will stop. When the power is
reinstated the heat gun settings will resume to the previous
temperature and air flow settings. HOWEVER, the heatgun
will not actually start until one of the 4 buttons under the
display has been pressed.
If the slide selector switch has been previously moved to
the off position when the power was interrupted, then the
selector switch will need to be moved back to the desired
temperature range and the heat gun started.
Intended use
When observing the safety rules and using the original
accessories, this hot air tool is intended for all applications
with hot air that are listed in these operating instructions.
Applications
•
Shrinking of shrink-down tubing, solder connectors and
solder terminals, packaging and electrical components.
•
Deforming of articles made from acrylic, PVC, and
polystyrene, tubing, plates and profiles, as well as
moist woods.
•
Welding of thermoplastic polymer, flooring materials
of PVC and linoleum, PVC-coated fabric, tarpaulins
and foils.
•
Soldering of tin, special silver solder, SMD elements,
cable lugs, and for loosening soldered connections.
•
Removal of old and even thick coatings of oil paint,
varnish and synthetic plaster.
•
Drying of colour shade samples, filler, adhesives,
construction joints and stucco forms.
•
Joining adhesives - Large-surface gluing with contact
adhesives, activation of pressure-sensitive adhesives,
acceleration of bonding processes, releasing of bonding
points as well as releasing or bonding of edge band or
veneer.
• Defrosting of icy stairs and steps, door locks, boot
lids, car doors or water pipes, as well as for defrosting
refrigerators and freezers.
11
Advertisement
Table of Contents
