Operation - 909 HG2000 Instruction Manual

Operation

Follow the steps below to turn on and operate
the HG2000 heat gun.
To operate the heat gun at the
pre-set low temperature 50°C.
1. Check to ensure the slide selector switch is in the Off
position. Plug in the mains cable into a 240V power
outlet, and turn on.
2. Slide the selector switch to position I. The temperature
display will show 50°C, being the set temperature in
position I.
NOTE: the temperature cannot be altered in setting position I.
3. To start the heat gun, press any one of the 4 buttons
under the display.
4. To change the air flow (speed of the fan): press the top
centre button to increase the fan speed, or the lower
centre button to reduce the fan speed. In total, there are
5 speed settings for the fan.
5. To stop the heat gun, slide the selector switch to the Off
position (O).
To operate the heat gun at higher
temperatures, up to 650°C.
1. Check to ensure the slide selector switch (11) is in the off
position (O). Plug in the mains cable into a 240V power
outlet, and turn the power point on.
2. Slide the selector switch to position II.
The temperature display will show the previous set
temperature in position II.
3. Start the heat gun by pressing
any one of the 4 buttons under
the display.
4. Select the temperature
required by, pressing the
button on the left hand side
marked to increase the
temperature or the button
on the right marked
decrease the temperature.
NOTE: the temperature range for position II is between
50°C and 650°C.
9
to