Table of Contents
Advertisement
STARTING THE GRIDDLE:
1. Turn on the main power switch for the
griddle.
a. Main power switch.
b. Power switch on the steam
generator.
2. Set control to the desired temperature.
(265
F minimum to cook, heating period is 20 mins.)
o
3. Allow griddle to reach set point temperature before
beginning to cook. Heating period is 20 mins.
STARTING AUTOMATIC STEAM INJECTION LIDS
WHEN COOKING:
NOTE: Steam injection will not turn on unless lid is lowered
to closed position and pushed towards back of griddle.
Slightly lifting lid and pulling forward will turn off steam.
Pushing lid back will turn steam back on.
GRIDDLE SHUT DOWN PROCEDURE FOR UN-
HEATED STORAGE:
1. Disconnect water and electrical supply.
2. Water will need to be drained and blown out with com-
pressed air from all components. It is recommended that
a qualified service agent do this.
2624, 2624S, 2636, 2636S Griddle
OPERATION
HOW TO SET TEMPERATURE:
A. Actual temperature reading.
B. Desired set temperature.
C. Factory set program function.
1. Increase desired set temperature.
2. Decrease desired set temperature.
OGDEN CONTROLLER 9200
•
Tap button 1 or 2 (up or down key) for less than 1 sec-
ond.
•
All four temperature digits on the lower display will light
with the first digit being brighter.
•
Advance to the digit you want to change by pressing but-
ton 1 or 2 (up or down key) for less than 1 second.
•
To change the value of the digit hold in the up or down
key. After 10 seconds the new value will be entered and
the display will read normally.
•
Tap either arrow button once to highlight all digits.
•
Once desired digit is highlighted hold the proper button
in to increase or decrease digits.
Refer to page 6 for illustrated help.
6
Advertisement
Table of Contents
