Philips HDRW 720/17 Owner's Manual page 83

PROBLEM SOLUTION
b
b
1 Open the disc tray with OPEN/CLOSE J . Insert the disc but do not close the tray.
2
Hold down the number button 2 on the remote control until the tray closes. The disc is
modified.
3
You can restore the disc to its original condition by pressing 1 .
There is a risk that you can no longer play the disc on other DVD players after this procedure.
Therefore, apply this function with particular care.
b
1
Clean the disc
2 Open the disc tray with OPEN/CLOSE J . Insert the disc but do not close the tray.
3
Hold down the red function button on the remote control until the tray closes. The disc is
prepared for erasing.
4
Start recording as with an empty disc.
b
1
Make sure that the surface of the disc is clean.
2 Open the disc tray with OPEN/CLOSE J . Insert the defect DVD+R but
.
3
Hold down 5 on the remote control until the tray closes. The disc will be read ('
appears on the display) and the DVD recorder will start the repair process. This may take up
to four times as much time as the recording, in which the error occurred.
4
If the disc is recovered, the index screen will appear.
Please observe the following:
The recovering procedure is successfully only if there was a previous recording on the disc.
Error during recording: The title may be missing.
Error while changing the title/index picture: The original title/index picture may be visible.
Error while finalizing: The disc appears not to have been finalized.
b
Open the disc tray with OPEN/CLOSE J . Insert the defect DVD+R but
1
.
2
Hold down 4 on the remote control until the tray closes.
' ' appears in the display. Finalizing begins. This may take up to three minutes.
3
If finalizing has been successful, the index screen will appear.
'