Download  Print this page

Maintenance - Black & Decker CS3651LC Original Instructions Manual

Hide thumbs


Table of Contents
Screw size
Pilot hole ø
No. 6 (3.5 mm) 2.0 mm
No. 8 (4 mm)
2.5 mm
No. 10 (5 mm)
3.0 mm
Drilling pilot holes
• Always apply a light pressure in a
straight line with the drill bit.
• Just before the drill tip breaks through
the other side of the workpiece, decrease
pressure on the tool.
• Use a block of wood to back up
workpieces that may splinter.
• Make an indentation using a centre
punch at the centre of the hole to be
drilled in order to improve accuracy.
The performance of your tool depends on
the accessory used. BLACK+DECKER and
Piranha accessories are engineered to high
quality standards and designed to enhance
the performance of your tool. By using
these accessories you will get the very best
from your tool. This tool uses screwdriver
bits with a 1/4" (6.35 mm) hexagonal shank.
Piranha Super-lok accessories are designed
for use with this tool.


Your BLACK+DECKER tool has been
designed to operate over a long period of
time with a minimum of maintenance.
Continuous satisfactory operation depends
upon proper tool care and regular cleaning.
Your charger does not require any
maintenance apart from regular cleaning.
Warning! Before performing any
maintenance on the tool, unplug the
charger before cleaning it.
• Regularly clean the ventilation slots in
(Original instructions)
Pilot hole ø
2.5 mm
3.6 mm
3.0 mm
4.5 mm
3.5 mm
5.0 mm
your tool and charger using a soft brush
or dry cloth.
• Regularly clean the motor housing using
a damp cloth. Do not use any abrasive or
solvent-based cleaner.
• Regularly open the chuck and tap it to
remove any dust from the interior.
There are no user servicable parts
• At the end of your products life return the
whole unit to your service agent or to a
local recycling station to have the battery
recycled. Do not throw the unit out with
household waste.


Table of Contents