Machine Configuration Programming Information - JLG 600SJC Service And Maintenance Manual

SECTION 6 - JLG CONTROL SYSTEM
Configuration Digit
NOTE: Machine configuration must be completed before any personality settings can be changed. Changing personality set-
tings first and then changing the model number of the machine configuration will cause personality settings to return to
default
MODEL NUMBER:
1
MARKET:
2
ENGINE:
3
GLOW PLUG:
5
STARTER LOCKOUT:
6
FUEL CUTOUT:
7
*This menu item is only visible if non dual fuel engines are selected.
ENGINE SHUT-
DOWN:
8
6-30
Table 6-5. Machine Configuration Programming Information
Number
6 600SC
0 ANSI USA
1 ANSI EXPORT
2 CSA
3 CE
4 AUSTRALIA
5 JAPAN
12 DEUTZ ECM: Deutz Engine Control Module (Tier 2 and 3)
16 DEUTZ ECM T4F: Deutz Engine Control Module (Tier 4 Final)
0 NO GLOW PLUGS: No glow plugs installed.
1 AIR INTAKE: Glow plugs installed in the air intake on the manifold.
2 IN-CYLINDER: Glow plugs installed in each cylinder.
0 DISABLED: Automatic pre-glow time determined by ambient air tempera-
ture; engine start can be attempted at any time during pre-glow.
1 ENABLED: Automatic pre-glow time determined by ambient air tempera-
ture; engine start is NOT permitted until pre-glow is finished.
0 RESTART: Engine allowed to be restarted multiple times when very low
fuel level is reached.
1 ONE RESTART: Engine allowed to be restarted once for 2 minutes when very
low fuel level is reached.
2 ENGINE STOP: Engine not able to restart when very low fuel level is reached.
0 DISABLED: No engine shutdown.
1 ENABLED: Shutdown engine when coolant temperature is greater than
110°C or oil pressure is less than 8 PSI.
Description
– JLG Lift –
Default
Number
1
0
14
2
0
0
1
3121607