Chapter 4
Converter Assembly Component Replacement Procedures
Snubber Boards
DC1 Terminal Screw
Mounting Screw
86
See Chapter 1 - Component Diagrams and Torque Specifications on page
locate components in these instructions.
Remove Components
1. Read and follow the Safety Precautions on page
Steps on page 13.
2. Remove safety shields and enclosure covers as needed.
3. Locate the Snubber Board(s) to be replaced.
R
4. Carefully label and disconnect the wires from Snubber Board(s) that will
be replaced.
5. Remove the DC1 terminal screw and mounting screw for the Snubber
Board(s) to be replaced.
6. Remove the Snubber Board(s) and properly discard.
Rockwell Automation Publication 20B-IN026C-EN-P - October 2015
12
and Important Initial
S
T
15
to