Setting Radio Stations; Station Memory - Teufel hulsta Manual

Radio playback
Select one of the 2 radio frequency ranges
as a source (see page 15):
FM – reception of mono and stereo sta-
tions from 87.5 bis 108 MHz, RDS mode
possible.
AM– reception of mono stations from 522
to 1.629 kHz.

Setting radio stations

Direct entry of the tuning frequency:
• Tap button 23 "FREQU." so that the
tuning frequency appears in the display
panel.
• With the number buttons 22 "1 ... 0"
enter the frequency without any decimal
or commas.
• Press the select button 37 "•".
Station search:
• Tap button 23 "FREQU." so that the
tuning frequency appears in the display
panel.
• With arrow buttons 27 „/"
set the tuning frequency:
Manually: Every time the button is
tipped, the frequency is increased or
decreased by one increment (FM: 0.05
MHz, AM: 9 kHz).
Automatically: Holding down the button
for a prolonged period of time start stati-
on scanning in the desired direction until
a station with suffi ciently strong transmit-
ting power is found.
The set frequency is displayed in the dis-
play panel. If the station is received in ste-
reo, the symbol „ ". "..." will also appear.
If the station transmits an RDS signal, the
frequency and the name of the station will
alternate in the display panel after a short
time.
Stereo/Mono
Troublesome interference may occur for
weak stereo stations in the FM mode. In
this case you can switch between mono
and stereo reception with button 29
"MODE".
41
39
37

Station memory

The device can save up to 30 FM stations
and 10 AM stations. You can conveniently
select the saved stations at the push of a
button.
Saving stations manually
• Set the desired station as described
above.
• Press button 30 "MEM".The question
"Store in P xx" will appear in the display
panel.
• With number buttons 22 "1...0" enter the
• desired memory slot number or select
the desired number with the arrow but-
tons 27 „/" "
• Press select button 37 "•".
• If the memory slot is already occupied,
the question "Overwrite?" will appear.
• If you would like to select another
memory slot, press button 28 "RETURN"
and start from the beginning.
• Press button 37 "•" to save. The notice
"OK" will appear in the display panel
briefl y.
The station has now been stored. The
device will return to normal operation after
5 seconds of button inactivity.
22
23
27
28
29
30
SEITE 23