Source Levels" Menu; Audio Mapping" Menu; Speaker Setup" Menu; System Setup Menu - Teufel hulsta Manual

"Source levels" menu

You can adjust the relative volume from
"–10" (decrease) to "+10" (increase) for
each audio source here.

"Audio Mapping" menu

Here you can assign an audio input to
each of the 3 HDMI inputs.
Example: If you would like to connect a
PC without HDMI output: with a DVI-to-H-
DMI adapter you transmit the video signal
while the audio signal is present at one of
the analogue inputs via a cinch cable (e.g.
"AUX 1").

"Speaker Setup" menu

Phase Sub
This allows you to activate and deactivate
the phase shift (180°) for the subwoofer.
Select the setting with which the subwo-
ofer produces the loudest and clearest
sound.
Lip Sync
Digital image processing in the TV set
requires some time. In order to keep the
image and sound synchronous, delay the
sound by a few milliseconds. Here you
can adjust the audio delay from 0 to
200 ms for each HDMI and other inputs in
order to keep the sound synchronous.
Distance
The surround sound effect may be
corrupted if the speakers are positioned
at different distances to the listening
position. To compensate for these
differences in run time, you can set slight
signal delays for all channels. Measure
the difference from the listening position
to the speakers and enter these values
in the menu. The system calculates the
required delays on this basis.

System Setup menu

HDMI
CEC (Consumer Electronics Control)
If this function has been activated (ON),
CEC compatible devices are controlled
with a control command issued via the
HDMI connection. For example, the
control unit and the connected devices are
automatically activated and deactivated
via the remote control TV set.
ARC (Audio Return Channel)
This option allows audio reception from
the TV via the HDMI cable for TV sets that
support this function. Audio from TV sets
runs to the control unit through the HDMI
cable without having to connect another
cable. If the ARC function is activated, the
9 "COAXIAL 1" input is no longer
available.
Possible settings: OFF, ON.
Important!
Please note that many TV sets
only have one HDMI input that
supports the ARC function.
• To use ARC you must also activate
CEC.
Note: if the CEC function is activated,
standby power consumption increases.
Auto-off
After a certain time of inactivity, the device
automatically switches to standby after a
preset time.
Possible values: 60 min. (default),
30 min., never.
Power On Level
Here you can set the volume of your
device when it is activated:
• last: the volume that was set at
deactivating
• fi xed (custom): fi xed volume from -40 dB
(low) to +10 dB (very loud).
SEITE 19