Input; Satellite Loudspeakers - Teufel hulsta Manual

Subwoofer connections

Input

Connect the LINE IN jacks 43
of the subwoofers, using the cinch cables
supplied, to the 5.1 output jacks
of the control unit.

Satellite loudspeakers

Check correct polarity!
• Connect clips of the same colour.
Otherwise sound quality suffers.
• The leads of the loudspeaker cables are
marked by different colours or shapes.
• On the rear side of the subwoofer you
will fi nd the connection clips 48 for the
satellite loudspeakers.
• Hear you can connect loudspeaker
cables directly or use the optional
banana plugs. In the following we only
describe direct connections.
1. Feed the loudspeaker cables supplied
from the subwoofer to each of the
satellite loudspeakers.Small hint:
Mark the cables at the subwoofer
end – this will help you if you have to
(dis)assemble the unit.
2. Split the single loudspeaker cable at
both ends down to about 30 mm and-
strip about 10 mm of the insolationoff
each cord.
3. Twist the stripped single wire ends
so that no wires are protruding.
Tin-coating is not necessary.
4. Turn the connector terminal anti-
clockwise Until loose. Feed the strip-
ped cable end into the now visible
hole. Close the terminal by turning it
clockwise. The cable has now been
clamped in place.
5. Connect the other end of the loudspe-
aker cable to the satellite loudspeakers
in the same way.
43
48
SEITE 13