Connecting To A Power Supply; Basic Functions; Activating And Deactivating; Selecting A Source - Teufel Concept C 300 WL Technical Description And Operating Instructions

Connecting to a power supply

• Ensure that the mains switch 7 "Power" has been
turned off ("0 OFF" setting).
• Connect the mains connector jack 8 with a power sup-
ply socket via the mains cord

Basic functions

Activating and deactivating

• Using the mains switch 7, you can activate or deacti-
vate your Concept C 300 WL. After activation, your
device is in standby mode and LED 1 "Standby" is red.
• With the button 1 "Standby" or 12, you can switch
your Concept C 300 WL to operating and/or
standby mode (Standby). In the operating mode, the
LED 1 "Standby" is blue.

Selecting a source

After activation, the USB sound card is activated as a
source.
• Using the button 14 "Input", you can switch the source
between the USB sound card and RCA jacks.
When you switch, the LED 1 "Standby" is purple
briefl y.

Adjusting the volume

• Increase the volume: Press the button 15 +.
• Decrease the volume: Press the button 15 –.

Adjusting the bass level

You can adjust the volume of the subwoofer separately.
1. Press the button 13 "Bass".
The LED 1 "Standby" is purple.
2. Adjust the base level as you like using the buttons 15
+ / – .
3. Press the button 13 "Bass".
The LED 1 "Standby" is again blue. If no button is
pressed for six seconds, the device will also switch to
normal operation.
10 • Concept C 300 WL
.
8 7
1
12
13
14
15