Konica Minolta bizhub pro 1100 Maintenance Manual page 68

4
Press [Front] or [Back] to select the print
side to be adjusted.
5
Enter the zoom ratio or the image shift
value using the keypad, [,], or [+] on the
screen or the Keypad on the control
panel.
- To specify the zoom ratio, press [Vertical] or
[Horizontal], then enter a value.
[Vertical] is used to adjust the zoom ratio in
the crosswise direction.
[Horizontal] is used to adjust the zoom ratio in
the paper feed direction.
To enlarge the print side, enter the value with
a positive mark (+). To reduce it, enter the
value with a negative mark (-).
The adjustment value changes 0.01% on a 1-
step basis.
Adjustment Range: [Vertical] -1.00 to +1.00,
[Horizontal] -0.50 to +0.50
- To move the print side upward, downward,
leftward, or rightward (image shift), press
[Up/Down] or [Right/Left], then enter the
value.
To move the print side upward or rightward,
enter the value with a positive mark (+). To
move the print side downward or leftward,
enter the value with a negative mark (-).
The adjustment value changes 0.1 mm on a
1-step basis.
Adjustment range: [Up/Down] / [Right/Left] -
10.0 to +10.0
- To switch the positive mark (+) and negative
mark (-), press [+/-].
- To reset a value, press [Clear].
- To adjust the zoom ratio and image shift,
check the status in the center of a page.
2-42